Server Scanner Installation
Last updated
Last updated
This guide will walk you through the steps required to install and configure the Scanner on your Windows server. The Scanner is a critical component of the Cybral Guard.
It is designed to scan files on the server, classify them using our advanced AI, and ensure your data is properly organized and protected. By following this guide, you can set up the Scanner easily, integrate it with your existing infrastructure, and start using the powerful data classification and protection capabilities of Cybral Guard.
To install the Cybral Guard Scanner Server, ensure the following prerequisite is met:
Windows Desktop Runtime 6.0.20 (x64): The presence of windowsdesktop-runtime-6.0.20-win-x64 on the server is required for the setup of the Scanner.
If this runtime is not present, the user will be prompted to install it during the setup process.
Obtain the Setup Wizard:
Ensure you have received the Cybral Guard setup wizard.
Run the Setup Wizard:
Launch the Cybral Guard setup wizard on your Windows server.
Follow the on-screen instructions provided by the wizard to initiate the installation process.
Follow the Installation Prompts:
The setup wizard will guide you through a series of installation prompts. These will include choosing the installation directory and configuring initial settings.
Select the appropriate options based on your organization's requirements and proceed to the next steps.
Confirm the Installation:
Once you have configured the necessary settings, the setup wizard will be ready to install the Scanner on your Windows server.
Scanner being installed:
This process may take a few minutes. Ensure that your server meets the required specifications for a smooth installation.
Complete the Installation
Verify Installation:
After the installation is complete, navigate to the Services section on your server to ensure the Scanner is now installed correctly and running.
To ensure the service is running smoothly, the Scanner will recheck the files after 12 hours. This process will occur after the installation to ensure that all files are correctly labeled and exposed for scanning.
Files on the server will be scanned one by one, except for those configured by the admin via the portal to be excluded from scanning.
The scanner performs a rescan every 24 hours. This routine check ensures that any updates or changes to the files are detected and reclassified if necessary.
